Chimney Sweep in Palm Bay, FL

Sweeping a factory-built system is a different job from brushing a brick flue, and it starts with the brush. The inner wall is thin stainless or aluminized steel, and a stiff wire brush scores it; in Brevard County's salt-bearing air a scratch there is where corrosion starts. Poly brushes sized to the pipe are the correct tool, and the seams and joints between sections get examined as the brush passes, because on a metal chimney the sweep doubles as a condition survey. The findings differ too. Where a fireplace is lit only on the coldest nights there may be little creosote to remove, and what comes down instead is debris and rust flake off the cap and termination, which still has to come out, because either blocks a flue. If you suspect an active chimney fire, leave the home and call 911 before requesting chimney service.

Cleaning scope depends on the fireplace or appliance, the accessible vent path, and the buildup found inside it. An obstruction or damaged component may require separate work rather than more sweeping. Ask which passages the cleaning covers and whether an inspection or any proposed repair is a separate item before comparing estimates.

• What fuel does the fireplace or stove use?
• When was it last used and cleaned, if known?
• Have you noticed smoke in the room, odors, debris or animal sounds?

Share what you already know. Do not climb onto the roof, dismantle equipment or operate a damaged fireplace to answer these questions.